三星481报警 [4624]<Freeze> Thermal mapping should be re-calibrated

如何能关闭啊

when you got wrong position of conveyor, it lost fiducial mark thermal teaching up on the conveyor.
4 A* T$ n% g; R$ Z) Y: ]7 oSo, first, you should take conveyor re-calibration.
/ l  ~3 z5 V1 PIf still same, you can take thermal mapping calibration the do all calibration below it.

8 y0 G$ G- `2 z( DAdditionally, you can also shut thermal mapping off with unchecking Enable thermal mapping in Thermal mapping calibration.
. Z1 ?3 H6 a2 H( @6 \5 r# v4 D