三星贴片机CP20,CP33,CP40-SA激光曲线调整教程

-
' H* s" b. t( F5 E  j) U. V2 X1 z3 u Work procedure
$ e2 U, W- d# _! _" G4 ~7 S- nHow to adjust the Profile
) M; Y$ P* N9 P1 N. M4 B0 ?7 q9 a1. Drive the MMI.
2. Execute the SA COMM.EXE(C:\SACOMM\SA COMM.EXE).
3. Connect the RS-232 Cable.
4. Turn off the SCM BOARD DIP S/W. (Facing upwards) - Refer to Figure 1.
1 m8 Y' H2 A! }1 [: y, W5. Press the RESET S/W.
# v5 a- d" a$ P* R$ f' l+ f% e. }6. Select the PROFILE.
7. Move down HEAD Z axis to reveal the edge.
0 j- E$ t% G7 N" ]/ s7 U' v8. Adjust the Volume Resistance, V2, to set the OFFSET.
! Q, j& v; N  d9. Adjust the Volume Resistance, V1 and V3, to position the PROFILE within standard
range (GRAY Level: 200 + 20).
; \; l7 S; ~9 ]3 F, H- {6 kAdjust V3 to control bright of LED, and make the shape of PROFILE to Wave type.
( l0 l# I2 a3 A3 d5 p5 N; _Adjust V1 to set the GRAY Level to 200 + 20.
- a0 S  g" F6 U- o10.Select the STOP.
/ G/ A( E; @( U

完整版下载附件查看

支持，赞一个

这么强,支持楼主，佩服

向楼主学习

向楼主学习

看帖要回，回帖才健康，在踩踩，楼主辛苦了！